Minky Chenille Stroller Blanket |
31" x 31" Stroller Blanket |
Minky Fabric and Quilt Batting |
Supplies:
Minky chenille fabric (approximately 2 yards)
Quilt batting
Sewing machine
Cotton thread
Straight pins
Measuring board or tape
Fabric scissors or rotary cutter
Pre-wash and dry the chenille fabric to pre-shrink before sewing.
Measure and cut two chenille fabric pieces and one batting piece to measure 31" long by 31" wide.
Measure and cut fabric and batting pieces to measure 31" x 31" |
Layer the three layers of fabric by placing the batting on the bottom, the chenille fabric face up and then the second chenille piece on top face down. Place pins along the edges of the three layers to secure.
Layer fabric pieces and pin along edges to secure |
Straight stitch along the edges of three of the four sides individually. Make sure to secure the thread at the end of each stitch by sewing forward all the way to the end and then sewing a few stitches in reverse and forward to the end again.
Once three of the sides are sown, sew the fourth side starting in the middle leaving an opening approximately 8 inches wide in order turn the fabric pieces right side out.
Once the fabric pieces are turned inside out, be sure to straighten out the corners. Then pin the open space closed and use that as your starting point to top stitch along the perimeter of the blanket carefully curving around each corner in order to secure the three layers. For my top stitch, I used a wavy stitch.
Wavy Stitch |
Minky Chenille Stroller Blanket |
Pink Minky Chenille Blanket:) |
Lauren
No comments:
Post a Comment